Basically I just cut a square hole measuring to the 1/2 mm so the drive would fit nice and snug… then epoxied in place. thought about doing drive mounts but at the time my fingers were torn up enough from doing the mesh on the front. :)
Thanks to all those who voted for me in the last round! I really did not think I would win that one. I guess this case is better than I think. I also think I am my worst critic.
Basically I just cut a square hole measuring to the 1/2 mm so the drive would fit nice and snug… then epoxied in place. thought about doing drive mounts but at the time my fingers were torn up enough from doing the mesh on the front. :)
How did you mount the drive sideways in that case since the drive bays are horizontal?
Congrats on the HardOCP and Engadget front page articles on the same day!
Nice work.
Thanks to all those who voted for me in the last round! I really did not think I would win that one. I guess this case is better than I think. I also think I am my worst critic.